Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

An approach to sustainable development: the case of Cuba

This paper analyzes the Cuban model of sustainable development and explains the causes that made Cuba the only country that meets the conditions of sustainability according to the Worldwide Fund for Nature (WWF). The Human Development Index has three main components: quality of life (health indicator measured as life expectancy at birth), knowledge (education indicator measured as adult literacy) and the standard of life (economic indicator measured by the Gross Domestic Income). This paper analyses the aspects of the educational and health system of Cuba and also of its energy policies that explain the excellent scores of the Human Development Index. Cuba shows a Human Development Index of 0.8 with an Ecological Footprint of 1.8?gha. This is achieved with a Gross Domestic Income lower than other countries with similar Human Development Index. The Ecological Footprint of Cuba is mainly determined by the CO₂ and the agricultural land footprint. The paper shows how the economic transition, after the economic crisis of the early 1990s, was realized without significantly increasing the Ecological Footprint.     

The toxicity of sulfamethazine to Daphnia magna and its additivity to other veterinary sulfonamides and trimethoprim

Sulfonamides (SAs), the oldest chemotherapeutic agents used for antimicrobial therapy, still play an important role in veterinary mass treatments. Consequently, traces of these compounds, alone or in combinations, have been repeatedly detected in the environment. Sulfamethazine (SMZ) deserves particular attention not only because it is the most used veterinary SA, but also due to its proven effects on fertility in mice and on thyroid hormone homeostasis in rats. In this study, after evaluating the acute toxicity to Daphnia magna of six veterinary SAs and trimethoprim (TMP), the additivity of SMZ to each other compound was tested using the isobologram method. Two reproduction tests on the same biological model were also performed in order to derive LOEC and NOEC of SMZ. The acute EC₅₀ was in the range 131–270 mg L⁻¹ for all the compounds tested with the exception of sulfaguanidine (EC₅₀ = 3.86 mg L⁻¹). In acute binary tests SMZ showed a complex interaction with sulfaquinoxaline (superadditivity, additivity or subadditivity) at the three different combination ratios tested, simple additivity to TMP and less than additive interaction when paired to the other SAs. LOEC and NOEC of SMZ obtained from reproduction tests were 3.125 and 1.563 mg L⁻¹, respectively. In conclusion, SMZ should not harm the crustacean population at environmentally realistic concentrations. Its toxicity is comparable to that of other systemic SAs, and their binary interactions are less than additive. The same can not be entirely said for enteric SAs, and considering that these compounds are administered at high doses and mostly excreted in unmetabolised form, further evaluation of their impact to the aquatic environment seems advisable.     

Canopy profiles of photosynthetic parameters under elevated CO2 and N fertilization in a poplar plantation

A poplar plantation has been exposed to an elevated CO2 concentration for 5 years using the free air CO2 enrichment (FACE) technique. Even after such a long period of exposure, leaves of Populus x euramericana have not shown clear signs of photosynthetic acclimation. Only at the end of the growing season for shade leaves was a decrease of maximum velocity of carboxylation (Vcmax) observed. Maximum electron transport rate (Jmax) was increased by FACE treatment in July. Assimilation rates at CO2 partial pressure of 400 (A400) and 600 (A600) micromol mol(-1) were not significantly different under FACE treatment. Most notably FACE significantly decreased stomatal conductance (g(s)) both on upper and lower canopy leaves. N fertilization increased N content in the leaves on mass basis (Nm) and specific leaf area (SLA) in both CO2 treatments but did not influence the photosynthetic parameters. These data show that in poplar plantations the long-term effects of elevated CO2 on photosynthesis do not differ considerably from the short-term ones even with N deposition.     

Experimental in situ chemical peroxidation of atrazine in contaminated soil

Lab-scale experiments of in situ chemical oxidation (ISCO), were performed on soil contaminated with 100 mg kg(-1) of atrazine (CIET). The oxidant used was hydrogen peroxide catalysed by naturally occurring minerals or by soluble Fe(II) sulphate, added in aqueous solution. The oxidation conditions were: CIET:H2O2=1:1100, 2 PV or 3 PV reaction volume, Fe(II):H2O2=0, 1:22, 1:11. Stabilized (with KH2PO4 at a concentration of 16 g l(-1)) or non-stabilized hydrogen peroxide was used. The pH of the reagents was adjusted to pH=1 with sulphuric acid, or was not altered. Results showed that the addition of soluble Fe(II) increased the temperature of the soil slurry and the use of stabilized hydrogen peroxide resulted in a lower heat generation. The treatment reduced the COD of the soil of about 40%, pH was lowered and natural organic matter became less hydrophobic. The highest atrazine conversion (89%) was obtained in the conditions: 3 PV, Fe(II):H2O2=1:11 with stabilized hydrogen peroxide added in two steps. The stabilizer only increased H2O2 life-time significantly when soluble Fe(II) was added. Results indicate as preferential degradation pathway of atrazine in soil dechlorination instead of dealkylation.     

Comparing the usability and reliability of a generic and a domain-specific medical error taxonomy

Medical error taxonomies are used to report and analyse patient safety incidents. Medical error taxonomies can be generic or domain-specific. In comparing generic and domain-specific medical error taxonomies, the literature compares the information both type of taxonomies classify. There is little evidence the taxonomies have been compared in terms of usability and reliability. Twenty nurses and 21 pharmacists participated in a study comparing the usability and reliability of a generic medical error taxonomy and a medication error taxonomy. The medical error taxonomies utilized were the Patient Safety Event Taxonomy and the NCC MERP Taxonomy of Medication Error. The study found no significant difference in the usability ratings of both taxonomies. The taxonomies required different amount of time to classify patient safety incidents and had significantly different reliability levels. The reliability of the NCC MERP Taxonomy of Medication Error was significantly different when used by nurses and pharmacists. The taxonomy was also preferred by the majority of participants. Some recommendations are made about the design of future medical error taxonomies.     

High-energy milling to decontaminate soils polluted by polychlorobiphenyls and atrazine

Mechanical energy has been used so far for running chemical reactions and for preparing new materials in absence of solvents. Very recently, the technology has been applied to solve environmental problems. In this paper, we describe the application of high-energy milling (HEM) for the remediation of soils contaminated by chlorinated organic compounds such as polychlorobiphenyls (PCBs) and agrochemicals like atrazine. NaBH₄ and LiAlH₄ have been successfully used for the total dehydrohalogenation of both classes of compounds, leaving a residue lower than 2 ppmw of the starting compound in the treated soil. LiAlH₄ was found to be more active than NaBH₄.     

实现可持续的城市发展：从褐色地带到环境管理

城市的空间形状和结构，是一个与政策关联度越来越大的主题 .在某些经济合作与发展组织 (OECD)国家，如土耳其和墨西哥，城市人口快速增长仍然是一个问题，但就绝大部分而言，成员国所关注的已经不是城市的人口规模，而是城市所占的实际面积 .最常见的情况下是由于市场和政策力量综合作用而出现的人口疏散这种现象产生多种非预期的后果 .其中包括随着工业和制造业活动衰落或往城市中心外地区迁移而出现的很多工业财产的废弃 .这种财产常被称为“褐色地带” .对于 OECD的工作来说，褐色地带遗址是被认为由于前工业、商业或政府的利用而遭到了污染或可能遭到污染因而被弃置不用的土地和建筑物 .     

Pesticides and groundwater quality protection

A simple approach for ranking the leaching of pesticides from surface soil is presented and tentatively calibrated with field data from an agricultural area. The approach is based on the calculation of a leaching index indicating the proportion of active ingredient, with respect to the quantity applied, leaching from a soil model in a given time interval (one year). In the selected area, 85 wells tapping an unconfined aquifer were sampled for groundwater pesticide residue analysis, in order to explore the index region between leachers and nonleachers.